Set Pnni Svcc Timers; Pnni Timers; Show Pnni Node Timers - Avaya M770 User Manual

Chapter 10 Managing PNNI Routing

Set PNNI SVCC timers

Use the following command to set the PNNI node SVCC timers:
Command:
Parameters:
Note: This request will set value for SVCC timers according to the index parameter.
Changes will take effect immediately.

PNNI Timers

Show PNNI node timers

Use the following command to show the PNNI node timers:
Command:
Examples:
The user is not expected to change any of these timers. However, if you need more
information about these timers you may refer to the PNNI specification
(af-pnni-0055.000), Annex E: Architectural Variables.
The <level> parameter is optional – if it is omitted, timers of all levels will be
displayed.
160
M15-155s8:/>route pnni config svcc set <level> <index>
<value>
<level> - internal PNNI level number: 1 is the physical
node
<index> - the index of the timer, to set all timers type
'all'
<value> - the value that the selected timer will receive
M15-155s8:/>route pnni config timers show <level>
Timers :
Name
-----------------------------------------------------------------
PtseHoldDown
HelloHoldDown
HelloInterval
HelloInactivityFactor
HlinkInactivityTime
PtseRefreshInterval
PtseLifeTimeFactor
RxmtInterval
RDelayedAckInterval
AvcrPm 10
AvcrMt 11
CdvPm 12
CtdPm 13
Index Current Default
Value Value
1 10 10
2 10 10
3 15 15
4 5 5
5 120 120
6 1800 1800
7 200 200
8 5 5
9 10 10
50 50
3 3
25 25
50 50
Avaya M770 ATM Switch User's Guide
Range Units
[ 1 - 600] 100ms
[ 1 - 600] 100ms
[ 1 - 600] secs
[ 1 - 20] fctr
[ 1 - 600] secs
[ 60 - 3600] secs
[100 - 500] %
[ 1 - 60] secs
[ 1 - 600] 100ms
[ 1 - 99] %
[ 1 - 99] %
[ 1 - 99] %
[ 1 - 99] %