Terminal Commands; Viewing The Number Of Lines; Setting The Number Of Lines; Viewing The Terminal Width - Avaya M770 User Manual

Terminal Commands

These commands allow you to configure how the BOOT Loader in a M770 ATM
Switch displays output on the terminal.

Viewing the number of lines

If the pager is enabled, this is the number of lines that a M770 ATM Switch will
output before pausing. For more information about the pager, see Viewing the
pager status later in this chapter.
To display the current number of lines, use the terminal lines command.
Command:
Output:

Setting the number of lines

To set the number of lines, use the terminal lines command.
Command:
Example:
Parameter:

Viewing the terminal width

To display the current terminal width, use the terminal width command.
Command:
Output:

Setting the terminal width

To set the terminal width, use the terminal width command.
Command:
Example:
Parameter:

Viewing the wordwrap status

To display the wordwrap status, use the terminal wordwrap command.
Command:
Output:
Avaya M770 ATM Switch User's Guide
M15-155s8:/>terminal lines
lines: 24
M15-155s8:/>terminal lines <rows>
M15-155s8:/>terminal lines 48
The number of lines to be displayed on
<rows>
the terminal.
M15-155s8:/>terminal width
terminal width 79
M15-155s8:/>terminal width <columns>
M15-155s8:/>terminal width 90
The number of columns to be displayed on the
<columns>
terminal.
M15-155s8:/>terminal wordwrap
no wordwrapping
Appendix B Using BOOT Loader
285