Resetting Signalling Statistics; Managing Connections; Listing All Virtual Circuits; Listing Switched Virtual Circuits - Avaya M770 User Manual

Resetting signalling statistics

To clear signalling counter for a virtual port, use the vport sig resetstats
command:
Command:
Example:
Parameter:
Output:

Managing Connections

Listing all virtual circuits

To list the details of all virtual circuits, use the vport connections all
command.
Command:
The vport connections all command displays all SVCs, PVCs, and internal
virtual circuits such as ILMI signalling that are set up on the M770 ATM Switch.
Information displayed in the output is described in Table 6.7.

Listing switched virtual circuits

To list the details of all SVCs, use the vport connections svcs command.
Command:
Example:
Parameters:
Avaya M770 ATM Switch User's Guide
M15-155s8:/>vport sig
M15-155s8:/>vport sig
The virtual port identifier is displayed as
<vport id>
<slot>.<port>.<virtual port number>
Done!
M15-155s8:/>vport connections all
M15-155s8:/>vport connections svcs [nomesh] [addr] [td]
[<vport id>] [src|dst] [<vportid>] [dir]
M15-155s8:/>vport connections svcs nomesh addr 8.1.0
Lists SVCs passing through the vport (except for LANE
[nomesh]
mesh SCVs)
Lists the ATM addresses where available
[addr]
Displays the ATM Traffic Descriptor
[td]
Lists all SVCs passing through the vport
[<vport id>]
Lists the incoming/outgoing SVCs from/to the vport
[<vport id>]
[src|dst]
Lists all SVCs between the two vports
[<vport id>]
[<vport id>]
Lists all SVCs from the 1st vport to the 2nd vport
[<vport id>]
[<vport id>]
dir
Chapter 6 Managing Virtual Ports
resetstats <vport id>
resetstats 2.9.0
89