Resetting The Stack Type Parameter; Resetting The Signalling Vpc Vpi Range - Avaya M770 User Manual

Chapter 6 Managing Virtual Ports
To reset the profile parameter for a virtual port, use the vport reset profile
command.
Command:
Example:
Parameter:

Resetting the stack type parameter

If you reset the virtual port's stack type parameter, the port will re-learn the stack
type when it is enabled and a remote device is connected. For more information
about this parameter, see "Setting the stack type parameter" on page 69.
Note: You must disable the virtual port before you can change or reset any virtual
port parameters. For more information about how to disable a virtual port, see
"Disabling a virtual port" on page 65.
To reset the stack type parameter for a virtual port, use the vport reset
stacktype command.
Command:
Example:
Parameter:

Resetting the signalling VPC VPI range

To reset the VPC VPI range that was previously assigned for Switched Virtual
Paths, use the following command:
Note: You must disable the virtual port before you can change or reset any virtual
port parameters. For more information about how to disable a virtual port, see
"Disabling a virtual port" on page 65.
Command:
Example:
Parameter:
Output
76
M15-155s8:/>vport reset profile <vport id>
M15-155s8:/>vport reset profile 8.1.0
The virtual port in the form <slot>.<port>.<virtual port number>.
<vport
id>
M15-155s8:/>vport reset stacktype <vport id>
M15-155s8:/>vport reset stacktype 8.1.0
The virtual port in the form <slot>.<port>.<virtual port number>
<vport id>
M15-155s8:/>vport reset sigvpcvpirange <vport id>
M15-155s8:/> M15-155Fs2:/> vport reset sigvpcvpirange 2.15.0
The virtual port in the form <slot>.<port>.0
<vport id>
Clearing sigvpcvpcirange value...
Done!
Avaya M770 ATM Switch User's Guide