Signaling Security State; Managing Signaling Security State; Displaying Signaling Security State - Avaya M770 User Manual

Signaling Security State

Managing Signaling Security State

The entire switch's signaling security can be set to Enabled or Disabled mode. When
the switch is in the Disabled mode all configured security parameters have no effect
and calls are never rejected by the Signaling Security application. The commands for
managing the switch's security state are available only in the Master Agent (MA)
module.
Command:
Command:

Displaying Signaling Security State

Command:
Output:
Avaya M770 ATM Switch User's Guide
Chapter 20
M15-155s8:/> vport sig sigsecurity disable
M15-155s8:/> vport sig sigsecurity enable
M15-155s8:/> vport sig sigsecurity show
Current overall signaling-security configuration
================================================
The switch security access control is Enabled.
Configured templates:
---------------------
Template name:
Action:
Source NSAP/MASK:
Destination NSAP/MASK: *
Template name:
Action:
Source NSAP/MASK:
Destination NSAP/MASK: *
Total number of templates: 2
Configured filters:
--type q to quit or any other key to continue--
-------------------
PRIORITY | VPORT | STATE | INCOMING TEMPLATE
TEMPLATE
==========================================================
==========
16 | 9.1.0
16 | 9.1.0 | ON
Total number of filters: 2
Secured vports list:
--------------------
9.1.0
Signaling Security (Access Control) Commands
accept-all
permit
*
reject-1
deny
39.30.20*
| ON | accept-all
| *
| OUTGOING
| *
| accept-all
251