Changing The Maximum Number Of Leses In An Elan - Avaya M770 User Manual

To change the formula for LES address that a LEC will call, enter the lane elan
lesaddress command:
Command:
M15-155s8:/>lane elan lesaddress <name> <les-address-formula> [<group-address>]
Example:
M15-155s8:/>lane elan lesaddress accounts_elan longest_match
Parameters:
<name>
<les-address-formula> Select one of the following formulas that the LEC will used to
<group-address>
Note: If only the name of the ELAN is entered then the LES address formula
currently in use will be displayed for the specified ELAN.

Changing the Maximum Number of LESes in an ELAN

This command is only valid if the specified ELAN supports distributed LANE
Services.
You must be aware of the following, if you change the number of distributed LESes
that the ELAN supports:
• If the maximum is increased the change will take effect immediately and
additional standby LES(es) will be promoted to active (if there are any).
• If the maximum is decreased the change will not affect the number of LESes
currently providing LE Services, but rather will determine whether active LESes
which get timed-out, get re-admitted or replaced by a standby LES.
Avaya M770 ATM Switch User's Guide
Chapter 16
The name of the ELAN. The name must be 32 characters or less.
locate the LES address: "group_address", "round_robin", or
"longest_match".
This parameter is only required, if a new group ATM address is
being supplied. It must be a 20-byte ATM address.
Managing an ELAN
223