Viewing Ilmi Information For A Virtual Port - Avaya M770 User Manual

Table 6.7
Field
Type

Viewing ILMI information for a virtual port

To display ILMI MIB information for the remote end of a virtual port, use the
ilmi show command.
Command:
Parameters:
The ilmi show command displays the information described in Table 6.8.
Table 6.8
Field
Stack Type
Private/
Public
IP address
Avaya M770 ATM Switch User's Guide
Output from the vport connections command (Continued)
Description
The type of connection.
PP:
PMP:
PVC:PP:
PVC:PMP:
RES:
DD_802.5:
DD_802.3:
MC_802.5:
MC_802.3:
CONTROL: LANE Control VC
LES_MESH: Distributed LES SVC mesh
BUS_MESH: Distributed BUS SVC mesh
DIAGNSTIC: Diagnostic
ILMI:
SIG:
M15-155s8:/>ilmi show [<vport id>]
The virtual port is displayed in the format:
<vport id>
<slot>.<port>.<virtual port number>.
If no virtual port id is entered then ILMI information is
displayed for all virtual ports.
Output from the ILMI show command for a specific virtual port
Description
The Stack Type that the remote device uses for signalling. This
can be UNI 3.0, UNI 3.1, UNI 4.0, IISP 3.0, IISP 3.1 or PNNI 1.0
The UNI type that is used. This is either Private or Public.
The IP address of the remote device attached to the virtual port.
Chapter 6 Managing Virtual Ports
Point-to-Point SVC.
Point-to-Multipoint SVC.
Point-to-Point PVC.
Point-to-Miltipoint PVC
Reserved circuit.
LANE Data Direct Token-Ring VC
LANE Data Direct Ethernet VC
LANE Multicast Token-Ring VC
LANE Multicast Ethernet VC
ILMI
Signalling.
91