Changing The Les Registration Mode - Avaya M770 User Manual

Chapter 15 Managing the LES/BUS
To change the ELAN name that the LES will host, use the
Command:
Example:
Parameters:
Note: The above command will take immediate effect. The command must be used
with care as all LECs will be thrown off the ELAN hosted by the LES. If a LEC is
configured to use the old ELAN name then it must be reconfigured manually to use
the new ELAN name.

Changing the LES registration mode

Before you change the registration mode of a LES, you must be aware of the mode
of the ELAN that it will be hosting and that the choice of mode is supported by the
device containing the LECS.
Refer to Table 15.3 a list of compatible LES and ELAN modes that should be used.
Table 15.3
LES mode
distributed
standby
manual
By default for the pre-defined ELANs, the LES mode is set to register automatically
and the LES modes are set to distributed:
To change the registration mode of the LES, enter the lane les mode command.
Command:
Example:
206
M15-155s8:/>lane les elan <old-name> <new-name>
M15-155s8:/>lane les elan marketing_eth mrk_eth
The current name of the ELAN that is hosted by
<old-name>
the LES that you want to change.
This parameter is case-sensitive.
The new ELAN that is somewhere on the network
<new-name>
and is known to the LECS that the local LES will
host. This parameter is case-sensitive.
Compatible LES and ELAN modes
LECS ELAN mode
auto
auto
manual
M15-155s8:/>lane les mode <elan-name> {distributed | standby | manual}
M15-155s8:/>lane les mode marketing_eth standby
lane les elan
Avaya M770 ATM Switch User's Guide
command.