Chapter 10
Managing PNNI Routing
<type>
<prefix>
<length>
<level>
Examples:
Remove the PNNI summary address prefix
To remove the PNNI summary address prefix use the following command.
Command:
Parameters:
Examples:
Set the PNNI summary table to the default
Use the following command to set the PNNI summary table to its default values.
For lowest-level node it is the switch's ATM prefixs. For higher-level nodes it's the
switch prefix where its length in bits is equal to the level where it resides.
Command:
158
I(nternal) or
<type>
<prefix>
E(xterior)
<length>
The ATM
<level>
address prefix.
Each octes is in
hex and is
separated by a
"."
length of the
prefix in bits (0-
152)
Internal level
number. 1 is
the lowest
(physical) node
disable I 39.84.0f.80.01.bc.61.de.81.00.00.60.00 104 1
M15-155s8:/>route pnni config summary remove <type> <prefix> <len>
<level>
<type>
- I(nternal) or E(xterior)
<prefix>
- The Atm address prefix
each octet is in hex and separate with '.'
<length>
- length of the prefix in bits (0-152)
<level>
– Internal level number. 1 is the lowest
(physical) node
set I 39.84.0f.80.01.bc.61.de.81.00.00.60.00 104 1
M15-155s8:/>route pnni config summary default <level>
Avaya M770 ATM Switch User's Guide