Fold Adjustments; Folding Horizontal Skew Adjustment - Ricoh B234 Service Manual

REPLACEMENT AND ADJUSTMENT

1.6 FOLD ADJUSTMENTS

1.6.1 FOLDING HORIZONTAL SKEW ADJUSTMENT

[D]
[C]
Important
• The fold unit is adjusted for optimum performance before the finisher is shipped
from the factory. Do this adjustment only if the edges of folded booklets are not
even.
1. Switch the copier on and enter the SP mode.
2. Europe, Asia: Use SP 6201 001 (this is for A3 paper).
North America: Use SP 6201 006 (this is for DLT paper).
[A]: If the original setting of SP6201 001 or 006 is not 0, then you must do the
vertical skew adjustment ( 1.6.2) after you finish this horizontal skew
procedure.
3. Use the 10-key pad to input "-2" (mm) for the SP value.
[B]: (Press [٠/ ] to enter the minus sign.)
4. Press [#] then exit the SP mode.
5. Open the front door and pull the stapling unit [A] out of the finisher.
6. Open the guide plate [B].
7. Loosen the adjustment screw [C] and then tighten until it stops. (Do not over
tighten.)
8. Remove the lock screw [D].
9. Raise the tip [E] of the adjustment screw very slightly and allow it to descend
under its own weight.
B836
[E]
[B]
B836R802.WMF
6
[A]
SM