Anritsu MT9083 Series Operation Manual page 78

Chapter 4 OTDR Commands
4.5.7 TRACe:LOAD:SOR? Command
Syntax: TRACe:LOAD:SOR?
Parameters: None
Description: Get SOR trace object.
Refer to Section 2.5 "Message Format – Binary Data" for further details.
Example: trac:load:sor? --- "BINARY ARRAY"
#524047 //SCPI data size message for binary data transfer followed by array of
SOR file bytes.
Response: SOR trace file as an array of bytes per SCPI binary transfer specifications
Errors: (–200, "std_execGen, Test is Active")
(–400, "std_queryGen, Trace Not Ready")
4.5.8 TRACe:LOAD:TEXT? Command
Syntax: TRACe:LOAD:TEXT?
TRACe:LOAD:TEXT?<wsp><start>
TRACe:LOAD:TEXT?<wsp><start>,<end>
Parameters: <start>
Floating point format
Range: 0.000000 – Current distance range.
<end>
Floating point format
Range: 0.000000 – Current distance range.
Start value must be less or equal to end value.
Description: TRACe:LOAD:TEXT? command has 3 mode.
TRACe:LOAD:TEXT?
Get SOR trace information in text format and full trace data.
TRACe:LOAD:TEXT? <start>
<start>: Start position of the trace data. Distance unit is km.
Get the trace data form specified start point to the end of distance range.
TRACe:LOAD:TEXT? <start>,<end>
<start>: Start position of the trace data. Distance unit is km.
<end>:End position of the trace data. Distance unit is km.
Get the trace data form specified start to end position.
Refer to Section 2.5 "Message Format – Binary Data" for further details.
4-26