Anritsu MT9083 Series Operation Manual page 77

4.5.4 TRACe:ANALyze:ORL Command
Syntax: TRACe:ANALyze:ORL
Parameters: <none>
Description: Performs ORL calculations on the trace.
This command is an overlapped command.
Example: trac:anal:orl
Response: None
Errors: (–200, "std_execGen, Test is Active")
(–200, "std_execGen, Trace Not Ready")
(–200, "std_execGen, Invalid Loss Mode")
4.5.5 TRACe:MDLOss? Command
Syntax: TRACe:MDLOss?
Parameters: None
Description: Get trace loss values. The returned values depend on current loss mode.
For single loss modes only first value is valid. If loss mode is not calculable the
returned value will be –99.99.
Example: trac:mdlo? --- –4.610,–99.99<END>
Response: Calculated loss values. Two comma separated numeric values.
Errors: (–200, "std_execGen, Test is Active")
(–400, "std_queryGen, Trace Not Ready")
4.5.6 TRACe:EELOss? Command
Syntax: TRACe:EELOss?
Parameters: None
Description: Get trace end-to-end loss. If loss mode is not calculable the returned value will be
–99.99.
Example: trac:eelo? --- –4.610<END>
Response: Calculated end-to-end loss value.
Errors: (–200, "std_execGen, Test is Active")
(–400, "std_queryGen, Trace Not Ready")
4.5 TRACe Subsystem Commands
4
4-25