Status Subsystem Commands; Status:operation[:Event]; Status:operation:condition; Status:operation:bit#:Condition - Anritsu MT9083 Series Operation Manual

3.3 Status Subsystem Commands

3.3.1 STATus:OPERation[:EVENt]?

Syntax: STATus:OPERation[:EVENt]?
Description: Queries the operation event register.
Parameters: None
Response: The bit value for the operation event register as a short value (0 .. +32767)
Example:
STAT:OPER? −> 0<END>

3.3.2 STATus:OPERation:CONDition?

Syntax: STATus:OPERation:CONDition?
Description: Queries the operation condition register.
Parameters: None
Response: The bit value for the operation condition register as a short value (0 .. +32767)
Example:
STAT:OPER:COND? −> 16<END>

3.3.3 STATus:OPERation:BIT#:CONDition?

Syntax: STATus:OPERation:BIT<n>:CONDition?
Description: This command accesses the user-definable bits in the OPERation register set. The
value of <n> is restricted from 8 to 12 and represents bits 8 through 12 in
the :STATus:OPERation status register.
Parameters: None
Response: The bit value for the operation condition register as a short value (0 .. 1)
Example:
STAT:OPER:BIT8:COND? −> 1<END>

3.3.4 STATus:OPERation:BIT#:ENABle

Syntax: STATus:OPERation:BIT<n>:ENABle<wsp><value>
Description: Sets the operation enable mask for the event register specified bit.
The value of <n> is restricted from 8 to 12 and represents bits 8 through 12
Parameters: The bit value for the operation enable mask as a short value (0 .. 1)
Response: None
Example:
STAT:OPER:BIT11:ENAB 1
All commands in this section are prepared for future functions. All the
registers regarding these commands are set to 0 now.
3.3

Status Subsystem Commands

3
3-11