Moving To Another Measurement Mode From Top Menu - Anritsu MT9083 Series Operation Manual

2.9 Moving to Another Measurement Mode from Top
Menu
2.9

Moving to Another Measurement Mode from Top Menu

In addition to OTDR measurement, this instrument has other built-in
measurement mode functions such as Light Source and Power Meter. To
use these measurements, it is necessary to switch measurement mode.
The remote control modes supported by the current MT9083A2/B2/C2
are Top Menu and OTDR (Standard).
This example explains how to switch the OTDR (Standard) mode to the
measurement mode from the Top Menu.
Switching between the Top Menu and OTDR (Standard) mode requires
the following:
Example of Use 1: To perform measurement at 1310 nm with
MT9083C2-053
INSTrument:CATalog:FULL?
>TOP_MENU, 1, OTDR_STD, 2
INSTrument:NSELect?
>1
INST:NSEL 2
INST:STAT 1
SOUR:WAV 1310
Queries measurement mode
supporting remote
At TOP_MENU, 1, OTDR_STD, 2:
Supports selection of Mode 1 at
Top Menu and Mode 2 at OTDR
(Standard)
Queries current mode
At 1 response:
Top Menu
Switches to OTDR (Standard)
Note: Measurement mode inactive
Enables OTDR (Standard) mode
Sets wavelength to 1310 nm
2
2-19