Checking Connection - Anritsu MT9083 Series Operation Manual

2.4 Checking Connection

Check that the link between the PC and instrument has been established.
1. Click Programs at the Windows Start menu.
2. Click Accessories.
3. Click Command Prompt.
4. Input the commands shown in the screen below.
This example shows how to set the IP address to 192.168.1.2.
Figure 2.4-1 Executing Ping Command
5. Check that the "Request timed out" message is not displayed.
Check that the following contents are correct.
- IP address, IP Netmask, Default Gateway, SCPI Port Number
- Cable connection
- USB-Ethernet converter connection
2.4

Checking Connection

2-7
2