2.2 Connecting Equipment
2.2.1 Connecting USB-Ethernet converter
Connect the USB-Ethernet converter to the USB Down Port on the top
edge of the ACCESS Master.
Figure 2.2.1-1 ACCESS Master and USB-Ethernet converter
If the converter is connected while the power is on, processing will be
suspended and the Remote Setup screen displayed. Refer to section 2.3
"Setting Ethernet" to set the IP address, etc.
When the converter is connected while the power is off, press Remote
Setup (f1) at the Top Menu displayed after power-on.
Settings such as the IP address, are saved at power-off. The previous
settings are read at the next power-on.
2.2
Connecting Equipment
2
2-3