Anritsu MT9083 Series Operation Manual page 69

4.4.10 SENSe:FIBer:BSC Command
Syntax: SENSe:FIBer:BSC<wsp><value>
Parameters: <value>
Floating point format
Range: –90.0 - –40.0
Description: Sets backscatter coefficient. This value will be used for the next test.
Example: sens:fib:bsc –83.0
Response: None
Errors: (–200, "std_execGen, Test is Active")
(–224, "std_illegalParmValue, Invalid Parameter Value")
4.4.11 SENSe:FIBer:BSC? Command
Syntax: SENSe:FIBer:BSC?
Parameters: None
Description: Queries backscatter coefficient.
Example: sens:fib:bsc? --- –83.0<END>
Response: Possible response is value in range:
–90.0 - –40.0
Errors: None
4.4.12 SENSe:HOFFset Command
Syntax: SENSe:HOFFset<wsp><value>
Parameters: <value>
Floating point format
Range: Offset value can be set plus/minus maximum distance range. (–300 to
300km)
Description: Set horizontal offset for the displayed trace(s). Offset value units – KM.
Example: Sens:hoff 10.0
Response: None
Errors: (–224, "std_illegalParmValue, Invalid Parameter Value")
4.4.13 SENSe:HOFFset? Command
Syntax: SENSe:HOFFset?
Parameters: None
Description: Queries horizontal offset for the displayed trace(s).
Example: sens:hoff? --- 0<END>
Response: Current horizontal offset value.
Errors: None
4.4 SENSe Subsystem Commands
4
4-17