Automatic Time - Standard Horizon CP500 Owner's Manual

3.2

AUTOMATIC TIME

The time information supplied by the GPS satellites is in Universal Time Coordinates (UTC
or Greenwich England Mean Time). To change the GPS Chart Plotter to read the correct
time, first you must figure out the offset and if it is Daylight Savings Time. For example on
the West coast of the United States or Pacific Standard Time the offset needed would be
–08:00 or –07:00 for Daylight Savings Time, Eastern Standard Time –05:00 or –04:00 for
Daylight Savings Time.
Figure 3.2 - Adjusting Time
The Time Setup menu allows you to enter a time zone offset for your location, selection to
automatically adjust the time for daylight savings and to configure the time in 12 or 24 hour
formats.
Figure 3.2a - Time Setup menu
NOTE
By setting the time in the steps below, the time shown on the Celestial page is automatically set up.
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
Page 26 CP500