Automatic Time - Standard Horizon CP500 Owner's Manual

3. Move the ShuttlePoint knob to highlight COURSE UP/NORTH UP and press [ENT] or
move the ShuttlePoint knob to the right.
4. Another popup window will be shown with NORTH UP and COURSE UP, move the
ShuttlePoint knob to the desired selection and press [ENT] or move the ShuttlePoint
knob to the right.
5. Press [CLR] or move the ShuttlePoint knob to the left to exit the menu and show the
Chart page.
When the GPS Chart Plotter is in COURSE UP mode a small arrow icon
Chart page indicating the direction of North.
3.2

AUTOMATIC TIME

The time information supplied by the GPS satellites is in Universal Time Coordinates (UTC or
Greenwich England Mean Time). To change the GPS Chart Plotter to read the correct time, first
you must figure out the offset and if it is daylight savings time. For example on the West coast of
the United States or Pacific Standard Time the offset needed would be –08:00 or –07:00 for daylight
savings time, Eastern Standard Time –05:00 or –04:00 for daylight savings time.
The Time Setup menu allows the users to know the offset for the area and automatically changes
the time in areas with Daylight Savings.
Page 26
NOTE
Figure 3.2 - Adjusting Time
Figure 3.2a - Time Setup menu
will be shown on the
CP500
R