Vhf Connections; Video Input/Output - Standard Horizon CP500 Owner's Manual

VHF connections

To connect the CP500 to a VHF, a Port will be needed to be selected. Refer to the ACC2
connections for a connection example.
The optional FF525 uses Port2 when connected and the optional Radar antenna uses Port5. When
these optional devices are connected use Port1, Port2 or Port4 Input and Output to connect to the
VHF radio.
Some manufacturers of DSC VHF's are not capable of receiving NMEA DSC sentences from the
CP500. Refer to the Owner's Manual and confirm the VHF can receive NMEA DSC and DSE
sentences.

Video Input/Output

The CP500 has:
· One VGA Output
Allows connection to a compatible TV or monitor using the optional VGAC10
adapter cable.
· Two NTSC or PAL Video Inputs
NTSC or PAL video inputs allowing a camera, DVD or VCR. To connect a video
source use the optional ACVC10 cable (3 pin to RCA phone adapter).
AVCV10 Video Adapter cable
Page 18
NOTE
2
3
1
1 = GND
2 = PWR+
3 = SIGNAL
CONNECTOR PINOUT
GPS ANT PWR & ACC 1 ACC 2 VIDEO OUT VIDEO IN 1
VGAC10
VIDEO IN 2
ACVC10
ACVC10
DVD Player
CP500