Satellite Imagery - Standard Horizon CP500 Owner's Manual

3. Move the ShuttlePoint knob to highlight SAFETY STATUS BAR and press [ENT] or
move the ShuttlePoint knob to the right.
4. The menu now shows the following selections:
ON: The Safety Status Bar is shown
OFF: The Safety Status Bar is not shown
ICON: In this mode the Safety Status Bar is not shown, rather a Warning Icon
will be shown in the top right corner on the Chart page when an alarm condition
is met.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to press the ShuttlePoint
knob to the left a few times.
6.0.6

Satellite Imagery

This function allows to overlay the satellite image for background chart. When it is set On,
the Palette is set to Normal to display the proper colors. To activate this function follow the
procedure below:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight SATELLITE IMAGERY and press [ENT] or
move the ShuttlePoint knob to the right.
4. The menu now shows two selections, ON or OFF.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the Chart page is shown.
Page 48
Figure 6.0.5a - Example of Chart page with Warning Icon displayed
Figure 6.0.6 - Example of Satellite Imagery
CP500