Dynamic Nav-Aids; Safety Status Bar (Dsi - Data Safety Indicator) - Standard Horizon CP500 Owner's Manual

6.0.4

Dynamic Nav-Aids

This function allows the blinking of the Nav-Aids to be turned On or Off. The blink period and
color of each Nav-Aid is read from the Nav-Aid attributes stored on the optional C-MAP
C-CARD. When the ship is inside the Nav-Aid nominal range, the light of the
J
EPPESEN
Nav-Aid will start blinking. When Dynamic Nav-Aids option is set to On, when the flashing
light is Off, or when fix position is out of the sector, the light color is displayed by using a faint
light color. To activate this function follow the procedure below:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight DYNAMIC NAV-AIDS and press [ENT] or move
the ShuttlePoint knob to the right.
4. The menu now shows two selections, ON or OFF.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the Chart page is shown.
6.0.5 Safety Status Bar
When the Safety StatusBar is enabled, a status bar with six boxes shows the status of certain
functions. Any warning or alarm condition is identified by the red color to indicate possible risk.
To activate this function follow the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
CP500
(DSI - Data Safety Indicator)
Figure 6.0.5 - Safety Status Bar
B
Y
Page 47