Table of Contents
Advertisement
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight COURSE UP/NORTH UP and press [ENT] or
move the ShuttlePoint knob to the right.
4. Another popup window will be shown with NORTH UP and COURSE UP, move the
ShuttlePoint knob to the desired selection and press [ENT] or move the ShuttlePoint
knob to the right.
5. Press [CLR] or move the ShuttlePoint knob to the left to exit the menu and show the
Chart page.
When the CP190i and CPF190i are in Course Up mode a small arrow icon
Chart page indicating North.
3.2
ADJUSTING TIME
The time information supplied by the GPS satellites is in Universal Time Coordinates (UTC
or Greenwich England Mean Time). To change the GPS Chart Plotter to display the local
time, first you must figure out the offset and if it is Daylight Savings Time. For example on
the West coast of the United States or Pacific Standard Time the offset needed would be
–08:00 or –07:00 for Daylight Savings Time, Eastern Standard Time –05:00 or –04:00 for
Daylight Savings Time.
CP190i and CPF190i
Figure 3.1.5 - Course Up/North Up menu
NOTE
Figure 3.2 - Adjusting Time
will be shown on the
Page 31
Advertisement
Table of Contents
