Personal Computer connection / setup
Any of the NMEA Ports can be used to Send and Receive Marks and Routes to PC
programs. The CP500 uses NMEA WPL and RTE sentences to share information from the
PC. Refer to the table below for connection to a serial DB9 connector.
Setting up the COM Port
The Send and Receive default is Port1.
To change the Port follow the directions below:
1. Press [MENU] twice. Move the ShuttlePoint knob to highlight ADVANCED SETUP and
press [ENT].
Page 16
D 9 PIN
B
CONNECTION
2
Receive +
Transmit +
3
5
Signal Common
C 500
P
NMEA Out
NMEA In
Green wire
CP500