Underwater Objects Settings; Customizing Chart Settings; Navigation Page - Standard Horizon CP500 Owner's Manual

When an empty level is entered, the message "No cartographic coverage" is shown on a window
in a corner of the chart display. The warning message is always displayed as long as the current
zoom has no data coverage.
12.0.11

Underwater Objects Settings

The following selections are used to control which Underwater Objects are shown on the
Chart page.
Underwater Object Limit : Selects the max depth value to display Underwater Objects. If value is set to 0Ft, the
Rocks
Obstructions
Diffusers
Wrecks
Choose the options: OFF (the object is not visible independently of the selected "Underwater Object
Depth Value"); ICON (the object icon is visible without tags, in the range selected from "Underwater
Object Depth Value" option); ICON+DEPTH (the object icon and tag is visible, in the range selected
from "Underwater Object Depth Value" option).
12.1

CUSTOMIZING CHART SETTINGS

The GPS Chart Plotter also allows you to customize items shown on the chart (discussed
in above sections) instead of using a pre-defined table discussed in Par. 12.0.4 Display Mode.
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight CHART CONFIGURATIONS and press [ENT]
or move the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight DISPLAY MODE and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight Custom and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up or down to select the desired item within the groups
Marine Settings, Depth Settings, Land Settings, Chart Settings or Underwater Settings
and press [ENT]. See the above sections for details on selections.
12.2

NAVIGATION PAGE

The Navigation page is useful to show information when heading to a Destination, following
a compass heading or navigating to a Mark or a Route. The default page is shown with a
Compass Rose, however this can be customized to show a Compass Tape.
1. To change to show the Compass Tape, select the Chart page, press [MENU]. Move the
ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
CP500
Underwater Objects are not shown on the charts. Menu options are greyed out. If value
is more than 0Ft (i.e. 10Ft), in the range from 0Ft to the selected value the Underwater
Objects are displayed according to their setting below.
:
Sets Off/Icon/Icon+Depth* the displaying of the Rocks.
: Sets Off/Icon/Icon+Depth* the displaying of the Obstructions.
:
Sets Off/Icon/Icon+Depth* the displaying of Diffusers (Diffuser is a structure on an outfall
through which liquids are discharged. The structure will usually project above the level of the
outfall and can be an obstruction to navigation).
:
Sets Off/Icon/Icon+Depth* the displaying of Wrecks.
NOTE*
NOTE*
Page 81