Highway Page - Standard Horizon CP500 Owner's Manual

3. Move the ShuttlePoint knob to highlight WINDOW SETUP and press [ENT] and press
[ENT] or move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight NAVIGATION PAGE and press [ENT] and
press [ENT] or move the ShuttlePoint knob to the right.
5. Move the ShuttlePoint up or down to select COMPASS TAPE and press [ENT].
6. Press [CLR] or move the ShuttlePoint knob to the right until the Chart page is shown.
The COG heading is computed and supplied to the plotter from the internal GPS or external GPS.
12.3

HIGHWAY PAGE

Shows a 3D view of the vessel travelling through the water when navigating to a Destination
point, Mark or following a Route. Press [ZOOM IN] or [ZOOM OUT] to change the highway
scale.
Page 82
NOTE
Figure 12.2 - Navigation page with Compass Rose
Figure 12.2a - Navigation page with Compass Tape
CP500