Cursor And Menu Selection Speed; Changing The Ship Icon - Standard Horizon CP500 Owner's Manual

3.1.2

Cursor and Menu selection speed

The GPS Chart Plotter allows you to control the speed the cursor moves when the
ShuttlePoint knob is pressed. To change the speed:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight CURSOR SPEED and press [ENT] or move the
ShuttlePoint knob to the right.
4. The menu now shows two selections, Chart and Menu which allow the Cursor Speed
to be selected as High, Medium or Low on the Chart page or within the menus.
5. With CHART or MENU selected, press [ENT] or move the ShuttlePoint knob to the right.
Move the ShuttlePoint knob to the desired setting and press [ENT] or move the
ShuttlePoint knob to the right.
6. Press [CLR] until the menu disappears or an easier method is to press the ShuttlePoint
knob to the left a few times.
7. Move the cursor on the Chart page and see if the speed is to your liking.
3.1.3

Changing the Ship Icon

The cursor may be changed to any of the following. The default setting is Icon 6.
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
Page 24
Figure 3.1.2 - Cursor Speed menu
Figure 3.1.3 - Ship Icons
CP500