Advanced Settings; Input/Output (Nmea, Ais, Radar); Input; Ouput - Standard Horizon CP500 Owner's Manual

13. ADVANCED SETTINGS

The Advanced Setup menu allows customization of many GPS functions, Alarms and
NMEA interfacing.
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
While in this menu you will see many selections which are described in the next sections.
13.0

INPUT/OUTPUT (NMEA, AIS, RADAR)

13.0.0 Input

The CP500 has 4 NMEA inputs and 5 NMEA outputs. These Ports may be set up to receive
and output the following.
· NMEA-0183 - NMEA devices* set to 4800 Baud (default setting)
· FF525 50/200kHz Black Box Fish Finder - refer to Fish Finder Owner's Manual
· C-COM - C-Weather refer to Section 15
· Radar - SI-TEX optional Radar refer to Radar Owner's Manual
· AIS 38400 - AIS Receiver, refer to Section 14
· MOBILARM - Mobil-arm receiver, refer to Section 16
· Disabled - allow the port to be disabled.
RS232 not opto-isolated electrical interface
When a Port is configured, both the Input and Output have the same setting.
Port1 is set to Radar, both the Input and Output wires are set to SI-TEX proprietary Radar
sentences. This means other devices should not be connected to the Input or Output wires.

13.0.1 Ouput

The ports may be setup to output NMEA sentences. The table below shows the default
setting each port:
Sentence
GLL
VTG
BWC
WCV
APA
APB
HDG
BOD
XTE
Page 90
Port1 Port2
On On
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
On On
NOTE*
NOTE
Port3
On
Off
Off
Off
On
On
Off
On
On
Port4 Port5
On On
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
Off Off
On On
CP500