Display Mode - Standard Horizon CP500 Owner's Manual

turn this function off. The default setting is On Points.
1. To change, press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and
press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT].
3. Move the ShuttlePoint knob to highlight AUTO INFO and press [ENT].
4. Move the ShuttlePoint knob up or down to highlight OFF, ON POINTS or ON ALL and
press [ENT] or move the ShuttlePoint knob to the right.
5. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page appears.

12.0.6 Display Mode

Selects from a pre-defined table what cartographic objects are displayed and which display
options are set. Pre-programmed settings are user selectable from Full, Medium, Low, Radar
(reduces the information on the display to simulate items that would be shown on a Radar
display. Please note this function is not actually showing Radar information it is only showing
what typically would be shown by a separate dedicated Radar display) and Tides modes.
Besides, the Custom mode is available as default and it is configurable by the user.
The following table shows the selections for each mode.
To change to one of the pre-programmed settings
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight CHART CONFIGURATIONS and press [ENT].
3. Move the ShuttlePoint knob to highlight DISPLAY MODE and press [ENT].
4. Move the ShuttlePoint knob up or down to select the preset and press [ENT].
5. Press [CLR] until the Chart page is shown.
CP500
Figure 12.0.5 - Example of Auto Info settings
Figure 12.0.6 - Display Mode settings
Page 77