Inserting A Waypoint Into A Route; Goto Route; Using [Goto] To Select Route - Standard Horizon CP500 Owner's Manual

9.5

INSERTING A WAYPOINT INTO A ROUTE

1. Place the cursor on the navigation line between two Waypoints and press [I
line between the two Waypoints is turned into a dotted line, see the following picture.
2. Move the ShuttlePoint knob to the desired location for the new Waypoint: the line will
"rubber-band", drawing a dotted line between the previous Waypoint and the cursor,
and another dotted line between the cursor and the next Waypoint (see the left side of
the above picture).
3. Once you have positioned the cursor at the location you want, press [ENT] (see the right
side of the above picture).
9.6

GOTO ROUTE

By having created some Routes, you can choose one of them to place a GOTO on.
9.6.0

Using [GOTO] to select Route

1. Move the ShuttlePoint knob to an open position (no buoy, warning etc. under the cursor)
on the Chart page.
2. Press [GOTO] to show the GOTO popup window.
3. Move the ShuttlePoint knob to highlight ROUTE and press [ENT].
4. The SELECT ROUTE popup window will be shown.
CP500
Figure 9.5 - Inserting Waypoint procedure (1)
Figure 9.5a - Inserting Waypoint procedure (2)
]. The
NSERT
Page 63