Gps Status Page; Waas/Egnos Setting; Gps Setup Menu - Standard Horizon CP500 Owner's Manual

(High Water). Let's say the High Water window shows 5Ft and the Low Water window shows
1Ft this means the water under your vessel over a 24 hour period of time could fall 4Ft (High
Water - Low Water). With your vessel in 15Ft of water and with a maximum water change
of 4Ft during the day, the worst case situation there will be 11Ft of water under your vessel.
12.5

GPS STATUS PAGE

The GPS Status page is used as a reference to see how well the GPS is receiving satellites.
The WAAS/GPS Icon area may change due to the satellite reception:
ACQUIRING : the GPS is trying to receive a valid position fix.
GPS2D : The GPS is receiving at least 2 satellites
GPS3D : the GPS is receiving at least 3 satellites.
WAAS 2D/3D : the GPS is receiving a 2D or 3D position and the correction from the WAAS satellite.
HDOP : Horizontal Dilution of Precision
VDOP : Vertical Dilution of Precision

12.5.0 WAAS/EGNOS Setting

From this page it is possible to disable the WAAS/EGNOS function following this procedure:
1. Press [MENU], move the ShuttlePoint knob to enter GPS STATUS page and press [ENT].
2. Press and hold [ENT]. The GPS Setup menu appears on the screen.
3. Move the ShuttlePoint knob to highlight DIFF CORRECTION SOURCE and press
[ENT].
4. Move the ShuttlePoint knob to highlight None (to disable) and press [ENT].
5. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the menu disappears.

12.5.1 GPS Setup Menu

Page 84
Figure 12.5 - GPS Status page
Figure 12.5.1 - GPS Setup menu
CP500