Adjusting The Time - Standard Horizon CPV550 Owner's Manual

ShuttlePoint knob to the desired selection and press [ENT] or move the ShuttlePoint
knob to the right.
4. Press [CLR] or move the ShuttlePoint knob to the left to exit the menu and show the
Chart page.
When the GPS Chart Plotter is in COURSE UP mode a small arrow icon
Chart page indicating the direction of North.
7.2

ADJUSTING THE TIME

The time information supplied by the GPS satellites is in Universal Time Coordinates (UTC
or Greenwich England Mean Time). To change the GPS Chart Plotter to read the correct
time, first you must figure out the offset and if it is daylight savings time. For example on the
West coast of the United States or Pacific Standard Time the offset needed would be –08:00
or –07:00 for daylight savings time, Eastern Standard Time –05:00 or –04:00 for daylight
savings time.
This map shows offset for standard time. For daylight saving time, subtract one hour from the offset time.
Page 44
NOTE
Figure 7.2 - Adjusting Time
NOTE
Figure 7.2a - Time Setup menu
will be shown on the
CPV550