Placing Cursor On The Ptx Icon; Delete Ptx; Goto Ptx - Standard Horizon CP500 Owner's Manual

When the same PTX is received again:
a. If the received PTX is not the active one, the user must confirm to navigate to it.
b. If the received PTX is the active one, navigation data is updated. The PTX icon appears at the
new position and a popup warning window appears.
16.4

PLACING CURSOR ON THE PTX ICON

Moving the ShuttlePoint knob so the cursor is over the PTX icon on the Chart page will show
an information window and allow you to Goto the location of the PTX, delete the PTX icon
or show the Alarm Status list as shown below.

16.4.0 Delete PTX

The Delete PTX function permanently removes the selected PTX from the MOBILARM
Alarm Status List and from the Chart page.
Using the ShuttlePoint knob, move the cursor over the PTX icon and then press [D
A warning popup window will be shown. Select YES and press [ENT].

16.4.1 Goto PTX

When Goto is selected on the GPS Chart Plotter, navigation will start to the PTX icon
location. After the GPS Chart Plotter has received a PTX MOB alarm, using the ShuttlePoint
knob move the cursor over the PTX to navigate to and then two Soft Keys under the display
will be shown:
a. [G ], when pressed will start navigation to the PTX MOB location
OTO
b. [L ], when pressed will show the MOBILARM Alarm Status List page. Refer to Par.
IST
2.4.2 for Alarm Status List.
Page 104
NOTE
Figure 16.4 - Example of PTX information window
Figure 16.4.1 - Example of Goto PTX
]
ELETE
CP500