Cursor Vs. Home Mode; Cursor And Menu Selection Speed - Standard Horizon CPF390i Owner's Manual

5. When you move the ShuttlePoint knob you will notice DST and BRG values in the Data
window change. This shows the Distance and Bearing from the GPS Fix of your vessel
to the position of the Cursor.
6. If the cursor is moved to the edge of the screen the GPS Chart Plotter will automatically
pan in the desired direction.
3.1.1

Cursor Vs. Home Mode

Cursor Mode
When the cursor is shown on the Chart page, the GPS Chart Plotter is in Cursor Mode.
In Cursor Mode the position of the vessel will not stay in the center of the page and will move
right off the edge of the screen (as your boat moves). Cursor Mode allows you to pan around
and look at areas on the chart. In this mode you can also create Marks, Routes, measure
distance and bearings from your current position.
Home Mode
When the ship icon is shown on the Chart page (cursor is not shown) you are in Home
Mode. Now as the ship moves through the water the vessel's position will be kept in the
center of the display.
To change from Cursor Mode to Home Mode press [CLR].
3.1.2

Cursor and Menu selection speed

The CP390i and CPF390i allow you to control the speed the cursor moves when the
ShuttlePoint knob is pressed. To change the speed:
Page 30
Figure 3.1.0c - GPS Status and Chart pages
NOTE
Figure 3.1.2 - Cursor Speed Menu
CP390i and CPF390i