Layer 2 Dynamic Aggregation Configuration Example - HP 6125G Configuration Manual

Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG
Interface
-------------------------------------------------------------------------------
BAGG1
The output shows that link aggregation group 1 is a load-shared Layer 2 static aggregation group
and it contains three Selected ports.
# Display the global link-aggregation load-sharing criteria on Device A.
[DeviceA] display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-mac address, source-mac address
The output shows that all link aggregation groups created on the device perform load sharing
based on source and destination MAC addresses.

Layer 2 dynamic aggregation configuration example

Network requirements
As shown in
• Device A and Device B are connected through their respective Layer 2 Ethernet interfaces
GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3.
Configure a Layer 2 dynamic aggregation group on both Device A and Device B, enable VLAN 10
•
at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20 at
one end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on source and
•
destination MAC addresses.
Figure 10 Network diagram
Configuration procedure
Configure Device A:
1.
# Create VLAN 10, and assign the port GigabitEthernet 1/0/4 to VLAN 10.
<DeviceA> system-view
AGG Partner ID
Mode
S none
Figure 10:
Select Unselect
Ports
3
45
Share
Ports Type
0 Shar