Dynamic Ip Address Assignment Configuration Example - HP A7500 Series Configuration Manual

Figure 26 Network diagram for static IP address assignment
Configuration procedure
Configure the IP address of VLAN-interface 2 on Switch A.
1.
<SwitchA> system-view
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ip address 10.1.1.1 25
[SwitchA-Vlan-interface2] quit
Configure the DHCP server
2.
# Enable DHCP.
[SwitchA] dhcp enable
# Enable the DHCP server on VLAN-interface 2.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] dhcp select server global-pool
[SwitchA-Vlan-interface2] quit
# Create DHCP address pool 0, configure a static binding, DNS server and gateway in it.
[SwitchA] dhcp server ip-pool 0
[SwitchA-dhcp-pool-0] static-bind ip-address 10.1.1.5
[SwitchA-dhcp-pool-0]
3030-3066-2e65-3234-392e-3830-3530-2d56-6c61-6e2d-696e-7465-7266-6163-6532
[SwitchA-dhcp-pool-0] dns-list 10.1.1.2
[SwitchA-dhcp-pool-0] gateway-list 10.1.1.126
[SwitchA-dhcp-pool-0] quit
Verification
3.
After the preceding configuration is complete, Switch B can obtain IP address 10.1.1.5 and other network
parameters from Switch A. You can use the display dhcp server ip-in-use command on the DHCP server
to view the IP address assigned to the client.

Dynamic IP address assignment configuration example

Network requirements
As shown in
•
10.1.1.0/24, which is subnetted into 10.1.1.0/25 and 10.1.1.128/25.
Figure 27, the DHCP server (Switch A) assigns IP addresses to clients in subnet
static-bind
51
client-identifier