Restoring The Default Settings For An Aggregate Interface; Configuring Load Sharing For Link Aggregation Groups; Configuring Load-Sharing Criteria For Link Aggregation Groups - HP 6125G Configuration Manual

Step
2. Enter Layer 2 aggregate
interface view.
3. Shut down the aggregate
interface.

Restoring the default settings for an aggregate interface

Step
1. Enter system view.
2. Enter Layer 2 aggregate interface view.
3. Restore the default settings for the
aggregate interface.
Configuring load sharing for link aggregation
groups

Configuring load-sharing criteria for link aggregation groups

You can determine how traffic is load-shared in a link aggregation group by configuring load-sharing
criteria. The criteria can be source/destination MAC addresses, source/destination IP addresses, or any
combination.
You can configure global or group-specific load-sharing criteria. A link aggregation group preferentially
uses the group-specific load-sharing criteria. If no group-specific load-sharing criteria are available, the
group uses the global load-sharing criteria.
NOTE:
The load sharing criteria configuration applies to only unicast packets, and can change the load sharing
criteria for unicast packets. Broadcast packets and multicast packets always use the default load sharing
criteria.
Configuring the global link-aggregation load-sharing criteria
Step
1. Enter system
view.
Command
interface bridge-aggregation
interface-number
shutdown
Command
system-view
interface bridge-aggregation
interface-number
default
Command
system-view
40
Remarks
Use either command.
By default, aggregate interfaces
are up.
Remarks
N/A
Remarks
N/A
Use either command.
N/A