Download Print this page

HP A3100-8 v2 SI Configuration Manual: Configuring Load Sharing For Link Aggregation Groups; Configuring Load-sharing Criteria For Link Aggregation Groups

A3100 v2 switch series layer 2 - lan switching.
Hide thumbs

Advertisement

To do...
Enter system view
Enter aggregate interface view
Restore the default settings for the
aggregate interface
Configuring load sharing for link aggregation
groups

Configuring load-sharing criteria for link aggregation groups

You can determine how traffic is load-shared across a link aggregation group by configuring
load-sharing criteria. The criteria can be IP addresses, MAC addresses, or any combination.
Follow these steps to configure global link-aggregation load-sharing criteria:
To do...
Enter system view
Configure the global
link-aggregation load-sharing
criteria
You can set the following global aggregation load-sharing criteria:
Source IP address
Destination IP address
Source MAC address
Destination MAC address
Source IP address and destination IP address
destination MAC address and source MAC address
Use the command...
system-view
interface bridge-aggregation
interface-number
default
Use the command...
system-view
link-aggregation load-sharing mode
{ destination-ip | destination-mac |
source-ip | source-mac } *
37
Remarks
Required
Remarks
Required
By default, the global
link-aggregation load-sharing
criteria include the source MAC
address for Layer 2 packet types
such as ARP, and the source and
destination IP addresses for Layer 3
packet types such as IP packets.

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: