Lldp Configuration Task List; Performing Basic Lldp Configuration; Enabling Lldp; Setting The Lldp Operating Mode - HP 3100 Series Configuration Manual

LLDP configuration task list

LLDP-related configurations made in Layer 2 Ethernet interface view take effect only on the current
port, and those made in port group view take effect on all ports in the current port group.
Complete these tasks to configure LLDP:
Task
Performing basic
LLDP configuration
Configuring CDP compatibility (available only on the HPE 3100 v2 EI)
Configuring LLDP trapping

Performing basic LLDP configuration

Enabling LLDP

To make LLDP take effect on specific ports, you must enable LLDP both globally and on these ports.
To enable LLDP:
Step
Enter system view.
1.
Enable LLDP globally.
2.
Enter Ethernet interface
3.
view or port group view.
Enable LLDP.
4.

Setting the LLDP operating mode

Step
Enter system view.
1.
Enabling LLDP
Setting the LLDP operating mode
Setting the LLDP reinitialization delay
Enabling LLDP polling
Configuring the advertisable TLVs
Configuring the management address and its encoding format
Setting other LLDP parameters
Setting an encapsulation format for LLDP frames
Command
system-view
lldp enable
•
Enter Layer 2 Ethernet interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual port-group-name
lldp enable
Command
system-view
181
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
N/A
By default, LLDP is globally
enabled.
N/A
Optional.
By default, LLDP is enabled
on a port.
Remarks
N/A