Preventing Motor Stalling During Operation - YASKAWA varispeed G7 CIMR-G7B series Instruction Manual

Preventing Motor Stalling During Operation

Stall prevention during operation prevents the motor from stalling by automatically lowering the Inverter's
output frequency when a transient overload occurs while the motor is operating at a constant speed.
Stall prevention during operation is enabled only during V/f control. If the Inverter output current continues to
exceed the setting in constant L3-06 for 100 ms or longer, the motor speed is reduced. Set whether to enable or
disable deceleration time using constant L3-05. Set the deceleration time using C1-02 (Acceleration time 1) or
C1-04 (Acceleration Time 2).
If the Inverter output current reaches the set value in L3-06 - 2% (Inverter Rated Output Current), the motor
will accelerate again at the frequency set or the acceleration time set.
Related Constants
Name
Con-
stant
Display
Number
Stall preven- 0: Disabled (Runs as set. With a
tion selection
during running
1: Deceleration time 1 (the
L3-05
运行中防失速选
2: Deceleration time 2 (the
择
Stall preven- Effective when L3-05 is 1 or 2.
tion level dur- Set as a percentage of the Inverter
ing running rated current.
L3-06
Usually setting is not necessary.
运行中防止失速 The factory setting reduces the set
值
values when the motor stalls.
Setting
Description
Range
heavy load, the motor may
stall.)
deceleration time for the stall 0 to 2
prevention function is C1-02.)
deceleration time for the stall
prevention function is C1-04.)
30 to
200
Control Methods
Change
Open
Factory during
V/f
Loop
Setting Opera-
V/f with
Vector
tion
PG
1
1 No A A No
160% No A A No
Machine Protection
MEMO
Open
BUS
Flux
Loop
Regis-
Vec-
Vector
ter
tor
2
No No 493H
No No 494H
49
6-