YASKAWA varispeed G7 CIMR-G7B series Instruction Manual page 355

Name
Con-
stant
Display
Number
STOP key dur- Sets the Stop Key in the run
ing control cir- mode.
cuit terminal 0: Disabled (When the Run
operation
o2-02
STOP 键
1: Enabled (Effective even
User constant Clears or stores user initial values.
initial value 0: Stores/not set
1: Begins storing (Records the
o2-03
2: All clear (Clears all recorded
用户参数保存
When the set constants are
recorded as user initial values,
1110 will be set in A1-03.
Frequency ref- When the frequency reference is
erence setting set on the Digital Operator fre-
method selec- quency reference monitor, sets
tion whether the Enter Key is neces-
sary.
o2-05
0: Enter Key needed
1: Enter Key not needed
频率指令设定
When set to 1, the Inverter
accepts the frequency reference
without Enter Key operation.
Cumulative
Sets the cumulative operation
operation time
time in hour units.
setting
o2-07
Operation time is calculated from
累积运行时间设
the set values.
定
Fan operation
Set the initial value of the fan
time setting
operation time using time units.
o2-10
The operation time accumulates
风扇累积运行时
from the set value.
间
Changing Frequency Reference and Display Units
Set the Digital Operator frequency reference and display units using constant o1-03. You can change the units
for the following constants using o1-03.
U1-01 (Frequency Reference)
•
U1-02 (Output Frequency)
•
U1-05 (Motor Speed)
•
U1-20 (Output Frequency after Soft Start)
•
d1-01 to d1-17 (Frequency references)
•
Switching Monitors when the Power Supply Is ON
Using constant o1-02, select the monitor item (U1-
ator when the power supply is turned ON. For monitors that can be displayed, refer to U1-
User Constants.
Setting
Description
Range
Command is issued from and
0 or 1
external terminal, the Stop
Key is disabled.)
during run.)
set constants as user initial
values.)
0 to 2
user initial values)
0 or 1
0 to
65535
0 to
65535
Digital Operator Functions
Control Methods
Change
Factory during
V/f
Setting Opera-
V/f with
tion
PG
1 No A A
0 No A A
0 No A A
0 hr No A A
0 hr No A A
[status monitor]) to be displayed on the Digital Oper-
MEMO
Open Open
BUS
Flux
Loop Loop
Regis-
Vec-
Vector Vector
ter
tor
1 2
A A A 506H
A A A 507H
A A A 509H
A A A 50BH
A A A 50EH
in Chapter 5
6-
149