YASKAWA varispeed G7 CIMR-G7B series Instruction Manual page 198

Con-
stant
Number
Input termi-
nal status at
U2-11
fault
输入端子状态
Output termi-
nal status at
U2-12
fault
输出端子状态
Operation
status at fault
U2-13
运行状态
Cumulative
operation
U2-14
time at fault
累积时间
Peak hold
current at
U2-21
fault
峰值保持电流
Peak hold
output
frequency at
U2-22
fault
峰值保持输出
频率
Note 1. The following errors are not included in the error trace: CPF00, 01, 02, 03, UV1, and UV2.
2. If the PUF fault is already indicated in U2-
* The minimum unit differs depending on the Inverter capacity. (0.01 A for Inverter of 0.4 kW to 7.5 kW, and 0.1 A for Inverter of 11 kW or more)
-84
5
Name
Description
Display
The input terminal status when
the previous fault occurred.
The format is the same as for U1-
10.
The output terminal status when
the previous fault occurred. The
format is the same as for U1-11.
The operating status when the
previous fault occurred. The for-
mat is the same as for U1-12.
The operating time when the pre-
vious fault occurred.
Displays the peak hold current
when the last fault occurred.
Displays the frequency value at
the moment the current reached
its peak value when the last fault
occurred.
Output Signal
Level During
Multi-Function
Analog Output
(Cannot be output.)
or U3- , even if the PUF fault is detected again, the fault trace is not updated.
Control Methods
Open Open
Min.
V/f Loop Flux Loop
Unit
V/f with Vec- Vec- Vec-
PG tor tor
1
- A A A A
- A A A A
- A A A A
1
A A A A
hr
0.01
A A A A
*
A
0.01
A A A A
Hz
MEMO-
BUS
Regis-
ter
tor
2
A 8AH
A 8BH
A 8CH
A 8DH
A 7E6H
A 7E7H