YASKAWA varispeed G7 CIMR-G7B series Instruction Manual page 145

Name
Con-
stant
Display
Number
Speed/torque Set the delay time from input-
control ting the multi-function input
switching "speed/torque control
timer change" (from On to OFF or
OFF to ON) until the control
is actually changed, in ms
units.
This function is enabled when
the multi-function input
d5-06
"speed/torque control
change" is set. In the speed/
控制切换时间
torque control switching
timer, the analog inputs hold
the values of when the
"speed/torque control
change" changes. Always be
sure to allow time for this
process to finish completely.
Rotation 0: Disabled
direction 1: Enabled
limit Usually, use a setting of 1
operation (enabled).
d5-07 selection Be sure to enable this setting
when rotating the motor in
the same direction as the
旋转方向限制
speed limit (winding opera-
动作
tion).
* The factory setting will change when the control method is changed. The flux vector factory setting is given.
Field Weakening: d6
User constants for the field weakening command are shown in the following table.
Name
Con-
stant
Display
Number
Field weak- Set the Inverter output volt-
ening level age when the field weakening
command is input.
It is enabled when the field
d6-01 weakening command is set
for a multi-function input.
弱励磁值
Set the level as a percentage
taking the voltage set in the
V/f pattern as 100%.
Field Set the lower limit in hertz of
frequency the frequency range where
field control is valid.
The field weakening com-
d6-02 mand is valid only at frequen-
cies above this setting and
励磁频率
only when the speed is in
agreement with the current
speed reference.
Setting Factory
Description
Range Setting
0 to
1000
0 or 1
Setting Factory
Description
Range Setting
0 to
100
0.0 to
0.0 Hz
400.0
Control Methods
Change
Open
during
V/f Loop
Opera-
V/f with Vec-
tion
PG tor
1
0 No No No No
1 No No No No
Control Methods
Change
Open
during
V/f Loop
Opera-
V/f with Vec-
tion
PG tor
1
80% No A A No
No A A No
User Constant Tables
MEMO-
Open
BUS
Flux Loop
Page
Regis-
Vec- Vec-
ter
tor tor
2
A A 29FH 6-128
No A 2A6H 6-128
MEMO-
Open
BUS
Flux Loop
Page
Regis-
Vec- Vec-
ter
tor tor
2
No No 2A0H -
No No 2A1H -
5-
31