Ramp Rise Rate Setup Program - Omron e5ck User Manual

4.3 Ramp Rise Rate Setup Program

Chapter 3 described programs that used the time setup method." Pro
grams were executed using a combination of SPs and step time values. The
E5CK T also supports the ramp rise rate setup method." By this method,
programs are executed using three program elements: target SP", rate
of rise" and soak time."
To select a ramp rise rate program, set the Step time/rate of rise program
ming" parameter (expansion mode) to 
Target SP
Step
Ramp step
Set each of the above program elements in the target SP 0 to 7", rate of
rise 0 to 7" and soak time 0 to 7" parameters.
In a ramp rise rate program, parameters are set to two steps as shown in
the figure above. The following figure shows the relationship between the
program and parameters.
Target SP 1
Soak time 0
Target SP 0
Target SP 2
Step 0
Target SP 0
Parameter
Rate of rise 0
Soak time 0
4.3 Ramp Rise Rate Setup Program
: rate of rise."
Soak time
Rate of rise
Time unit of ramp rate
N N+1
Soak step
Soak time 1
1 2 3
Target SP 1
Rate of rise 1
Soak time 1
Soak time 2
4 5
Target SP 2
Rate of rise 2
Soak time 2
4–7