Omron e5ck User Manual page 101

Remote/Local
• Switches between remote and local operation.
• To change the parameter setting during remote operation, use the communications
function. To change the parameter setting during local operation, change the setting
Function
on the E5CK T controller. You can check the parameter setting by both communica
tions and on the E5CK T controller regardless of whether the controller is switched
to remote or local operation.
"
Setting
F Related description
Chapter 6 Using the Communications Functions
F Related parameters
See
Communication stop bit" Communication data length" Communication parity"
Communication baud rate" Communication unit No." Event input assignment
1" (option mode)
F Option units
E53 CK01/03
Model
Standby time
• Sets the time until program operation is started after the run instruction is issued.
Function
Setting
F Related description
4.6 Setting Running Conditions/Starting the program run/Standby operation (page
4 20)
See
F Related parameter
Standby time monitor" (level 0 mode)
Setting Range
": remote / " ": local
Setting Range
0.00 to 99.59
Conditions of Use
The communications function must be in
use.
Default
Unit
Hour, minute
Level 2 Mode
Default
0.00
5–23