Option Mode - Omron e5ck User Manual

CHAPTER 5 PARAMETERS

Option Mode

• The parameters in this mode can be used only when the security" parameter (pro
tect mode) is set to 0" and 1".
• You can select this mode only on controllers that support optional functions. In this
mode, you can set the communications conditions, transfer output and event input
parameters to match the type of optional function supported on the controller.
• To select this mode, press the
to the menu display. If you select [
the
• To select parameters in this mode, press the
use the
• The following table shows the parameters supported in this mode and the page where
the parameter is described.
5–44
key for 1 second minimum, the controller enters the option mode.
or keys.
Symbol
Event input assignment 1
Communication stop bit
Communication data length
Communication parity
Communication baud rate
Communication unit No.
Transfer output type
Transfer output upper limit
Transfer output lower limit
key for 1 second minimum. The display changes
] using the and
key. To change parameter settings,
Parameter Name
keys, and then press
Page
5-45
5-46
5-46
5-46
5-46
5-46
5-47
5-47
5-47