Starting And Stopping Operation - Omron e5ck User Manual

CHAPTER 3 BASIC OPERATION

3.7 Starting and Stopping Operation

RUN/RST
F Manipulated vari-
able at reset
Using Event Input
3–20
• To start program operation (that is, switch from the reset state to run
operation), press the
• To stop program operation (that is, switch from run operation to the re
set state), press the
RUN/RST
controller has stopped operating (reset state), the RST LED lights.
• The controller cannot be reset during auto tuning (A.T.).
• Specify the manipulated variable ( 5.0 to 105.0%) in the MV at reset"
parameter (level 2 mode) to output the manipulated variable during
reset. Default is 0.0:0.0%".
• When the controller is reset in the manual mode, the manual MV takes
precedence.
• Both the MV limitter and MV change rate limitter are ineffective against
the manipulated value at reset.
On the E53 CKB, run/reset can be selected by event input.
For details on how to use event input, see 4.7 How to Use Event Input, page 4 17.
key for one second minimum.
RUN/RST
key from two seconds minimum. When the