Level 2 Mode - Omron e5ck User Manual

CHAPTER 5 PARAMETERS

Level 2 Mode

• The parameters in this mode can be used only when the security" parameter (pro
tect mode) is set to 0" to 2".
• This mode contains the auxiliary parameters for adjusting control. These parame
ters include parameters for limiting the manipulated variable, parameters for
switching between remote and local operation, and parameters for setting the LBA
(Loop Break Alarm), alarm hysteresis, and input digital filter values.
• To select this mode, press the
to the menu display. If you select [
press the
• To select parameters in this mode, press the
use the
• The following table shows the parameters supported in this mode and the page where
the parameter is described.
5–22
key for 1 second minimum, the controller enters the level 2 mode.
or keys.
Symbol
Remote/Local
Standby time
LBA detection time
MV at reset
MV at PV error
MV upper limit
MV lower limit
MV change rate limit
Input digital filter
Alarm 1 hysteresis
Alarm 2 hysteresis
Alarm 3 hysteresis
Input shift upper limit
Input shift lower limit
key for 1 second minimum. The display changes
] pressing the
key. To change parameter settings,
Parameter Name
and keys, and then
Page
5-25
5-25
5-26
5-26
5-27
5-27
5-27
5-27
5-28
5-29
5-29
5-29
5-29
5-29