Fixing Settings; Selecting Parameters 1 - Omron e5ck User Manual

CHAPTER 1 INTRODUCTION
JSelecting
parameters
JFixing settings
1–10
• If you select [ ], [
level 0, program, level 1 and level 2 modes, respectively, are selected.
These modes are selected with control still continuing.
• If you select[ ] [
setup, expansion, option and calibration modes, respectively, are se
lected.
When these modes are selected, the control is reset. So, control outputs
and auxiliary output are turned OFF. When another mode is selected
while in these modes control, reset is canceled.
• To set the controller to the protect mode or to return to the level 0 mode
from the protect mode, press the
neously for 1 second minimum.
• To set the controller to the manual mode, press the
cond minimum with the
return to the level 0 mode in the manual mode, press the
second minimum with the
first in this operation.
• When the controller is not in the manual mode, each press of the
switches the parameter in the respective mode.
Parameter
Parameter
1
• If you press the key when at the final parameter, the display returns
to the top parameter for the current mode.
• When you change parameter settings or contents, specify the parameter
using the or
seconds or press the
• When another mode is selected, the content of the parameters before the
mode was selected is fixed.
• When you turn the power OFF , you must first fix the settings and param
eter contents (by pressing the
settings and parameter contents are sometimes not changed by merely
pressing the or
], [ ] or [
] [ ] or [ ] in the menu display, the
key and the
RUN/RST
key held down in the level 0 to 2 modes. To
key pressed. Be sure to press the
Parameter
2 3
keys, and either leave the setting for at least two
key. This fixes the setting.
key or selecting another mode). The
keys.
] in the menu display, the
key simulta
key for one se
key for one
key
key
Parameter
n