Setup; Draw Out; Setting The Input Type Jumper - Omron e5ck User Manual

CHAPTER 2 PREPARATIONS

2.1 Setup

JDraw-out
JSetting the input type jumper
2–2
The following section describes how to draw out the internal mechanism
from the housing and how to set the input type jumper.
Draw out the internal mechanism from the housing.
(1) Press in both of the hooks on the left and right sides of the front panel
to unlock the internal mechanism from the housing.
(2) Draw out the internal mechanism towards you holding both sides of
the front panel.
• For details on where the input type jumper is located, see the figure on
page 1-2.
• Set the jumper to one of temperature input, voltage input or current in
put matched to the type of sensor connected to the input terminal.
I : Current input
TC/PT : Temperature input
• The input type jumper is factory-set to TC/PT (temperature input)".
• When you disconnect or insert the input type jumper, do not hold it di
rectly by its pins.
• When you have finished setting the input type jumper, insert the inter
nal mechanism back into the housing.
• To do this, push in the internal mechanism until you hear the hooks on
the front panel snap into place.
V : Voltage input